Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Using the J-37624 pinion bearing installer (2) and the GE-8092 driver handle (1), Install the inner pinion bearing cup into the pinion gear bearing retainer.
- Using the J-8608 pinion bearing cup installer (2) and the GE-8092 driver handle (1), install the outer pinion bearing cup into the pinion gear bearing retainer.
- Apply sealant to surface of the selective shim. Refer to Adhesives, Fluids, Lubricants, and Sealers .
- Install the pinion gear bearing retainer and bolts tighten to 88 (65 lb ft).
- Install the drive pinion flange/yoke and/or oil seal. Refer to Drive Pinion Flange/Yoke and/or Oil Seal Replacement .
- Install the rear propeller shaft from the vehicle. Refer to Rear Propeller Shaft Replacement .
- Install the rear axle shafts. Refer to Rear Axle Shaft and/or Gasket Replacement .
- Fill the axle with axle lubricant. Refer to Differential Oil Replacement (8.6 Inch Axle) , Differential Oil Replacement (10.5 Inch Axle) , Differential Oil Replacement (9.5LD Inch Axle) .
- Remove the support and lower the vehicle.
CAUTION:
Refer to Fastener Caution .