LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 482 (Rear Drive Axle) >> Repair Instructions >> Differential Overhaul (10.5 Inch Axle) >> Disassemble Procedure

Disassemble Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the differential side bearings. Refer to Differential Bearing Replacement .
  2. Remove the differential ring gear. Refer to Drive Pinion and Ring Gear Replacement (10.5 Inch Axle) , Drive Pinion and Ring Gear Replacement (8.6, 9.5LD Inch Axles) .
    3. Fig 1: View Of Proper Differential Side Gear & Thrust Washer On Differential Pinion Gears Position
    GM2153858Courtesy of GENERAL MOTORS COMPANY
  3. Separate the differential case (1).
    4. Fig 2: Exploded View Of Differential Assembly
    GM2153694Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    If the differential pinion gears, the differential side and the thrust washers are going to be reused, mark the components so they can be re-installed in their original location in the differential case.

  4. Remove the pinion gears (2), thrust washers (1) and the differential spider (3) from the differential case (6).
  5. Remove the differential side gears (4) and the thrust washers (5) from the differential case (5).
scientia non olet · About LEMON Manuals