LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 482 (Rear Drive Axle) >> Repair Instructions >> Differential Oil Replacement (10.5 Inch Axle) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Axle Drain Plug
    GM2148679Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  1. Install the rear axle drain plug (1) and tighten to 33 N.m (24 lb ft).
  2. Fill the rear axle with the proper fluid. Refer to Approximate Fluid Capacities , and Fluid and Lubricant Recommendations .
    3. Fig 2: Identifying Axle Fill Plug
    GM2148605Courtesy of GENERAL MOTORS COMPANY
  3. Install the fill plug (1) and tighten to 60 N.m (44 lb ft).
  4. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals