LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 482 (Rear Drive Axle) >> Repair Instructions >> Differential Bearing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the differential assembly. Refer to Differential Replacement (10.5 Inch Axle) , Differential Replacement (8.6, 9.5/9.5 LD Inch Axles) .
    2. Fig 1: View Of Differential Side Bearing
    GM680400Courtesy of GENERAL MOTORS COMPANY
  2. Remove the differential side bearings by doing the following:
    1. For the 8.6 inch axle, install the differential assembly into a vise.
    2. For the 10.5 inch axle, place a block of wood on each side of the differential assembly.

      Install the differential assembly into a vise.

    3. For the 8.6 inch axle, install the J 22888-20A  puller (2) and the J 8107-4  plug (1) over the differential case side bearing bore.
    4. Using the J 22888-20A  puller (2), and the J 8107-4  plug (1) or the J 36597  pilot (1), remove the differential side bearings.
scientia non olet · About LEMON Manuals