LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 482 (Rear Drive Axle) >> Repair Instructions >> Differential Bearing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Differential Side Bearing Into Position
    GM651740Courtesy of GENERAL MOTORS COMPANY
  1. For the 8.6 inch and the 10.5 inch axles, install the differential side bearings by doing the following:
    1. To protect the differential case for the 8.6 inch axle, install the J 8107-4  plug in the case on the side opposite the bearing installation.
    2. For the 8.6 inch axle, install the J 21784  installer (2) and the J 8092  handle (1), on the differential case bearing as shown in illustration.
    3. Using a hammer and the J 21784  installer (2) or the J 29710  installer (2) and the J 8092  handle (1), install the side bearings.
  2. Install the differential assembly. Refer to Differential Replacement (10.5 Inch Axle) , Differential Replacement (8.6, 9.5/9.5 LD Inch Axles) .
scientia non olet · About LEMON Manuals