LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 481 (Disc Brake System) >> Repair Instructions >> Front Brake Caliper Hardware Replacement (1500 Series) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Caliper Pins, Seals & Bushings
    GM1479416Courtesy of GENERAL MOTORS COMPANY
  1. Lubricate the caliper bushings, bolts and seals with high temperature silicone brake lubricant.
  2. Install the caliper pin bushings, seals and pins to the caliper bracket.
    3. Fig 2: Caliper Bracket
    GM1479405Courtesy of GENERAL MOTORS COMPANY
  3. Install the brake pad retainers to the caliper bracket.
  4. Install the brake pads.
    5. Fig 3: Caliper Bracket
    GM1479403Courtesy of GENERAL MOTORS COMPANY
  5. Install the caliper to the caliper bracket. Refer to Front Brake Caliper Replacement (1500 Series) , Front Brake Caliper Replacement (2500 Series) .
  6. Slowly apply pressure to the brake pedal until a firm pedal is achieved.
  7. Fill the master cylinder reservoir to the proper level with clean brake fluid, if necessary. Refer to Master Cylinder Reservoir Filling .
  8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
scientia non olet · About LEMON Manuals