LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Air Suspension) >> Repair Instructions >> Valve Automatic Level Control Solenoid Replacement (Single Compressor) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Do NOT remove an air supply pipe in an attempt to depressurize the air suspension. Always follow the Air Suspension Depressurization Procedure in Air Suspension. Failure to follow this procedure may cause personal injury or damage to the vehicle.
  1. Remove the compressor assembly from the vehicle and place on a bench. Refer to Compressor Assembly Automatic Level Control Air Replacement (Dual Compressors)  or Compressor Assembly Automatic Level Control Air Replacement (Single Compressor) .
    2. Fig 1: Solenoid Assembly
    GM1234313Courtesy of GENERAL MOTORS CORP.
  2. Unlock and disconnect the electrical connector from the pressure transducer/sensor by turning the connection counterclockwise.
    3. IMPORTANT: Note the port location of the air lines for reassembly.
  3. Remove the air lines. Refer to Air Suspension Air Line Replacement .
  4. Disconnect and remove the pigtail harness from the compressor assembly mounting bracket.
  5. Remove the mounting screws (2).
  6. Remove the solenoid assembly (1).
scientia non olet · About LEMON Manuals