LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Air Suspension) >> Repair Instructions >> Valve Automatic Level Control Solenoid Replacement (Dual Compressors) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Solenoid Assembly
    GM1455955Courtesy of GENERAL MOTORS CORP.
  1. Install the solenoid assembly (1).
    2. NOTE: Refer to Fastener Notice .
  2. Install the mounting screws.

    Tighten:  Tighten the screws to 5.0 N.m (44 lb in).

  3. Install and connect the pigtail harness to the compressor assembly mounting bracket.
  4. Install the air lines. Refer to Air Suspension Air Line Replacement .
  5. Connect and lock the electrical connector to the pressure transducer/sensor by turning the connection clockwise.
  6. Install the compressor assembly to the vehicle. Refer to Compressor Assembly Automatic Level Control Air Replacement (Dual Compressors)  or Compressor Assembly Automatic Level Control Air Replacement (Single Compressor) .
scientia non olet · About LEMON Manuals