LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Air Suspension) >> Repair Instructions >> Module Assembly Electronic Suspension Control Replacement (Single Compressor) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Control Module & Bracket
    GM1234301Courtesy of GENERAL MOTORS CORP.
  1. Install the control module to the bracket.
  2. Connect the electrical connection (2).
  3. Install the compressor assembly to the vehicle. Refer to Compressor Assembly Automatic Level Control Air Replacement (Dual Compressors)  or Compressor Assembly Automatic Level Control Air Replacement (Single Compressor) .
  4. Perform the suspension position calibration procedure. Refer to Suspension Position Calibration .
scientia non olet · About LEMON Manuals