LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Air Suspension) >> Repair Instructions >> Inflator Air Switch Replacement (SUV) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the air inflator switch harness and the air line from the air compressor.
  3. Lower the vehicle.
    4. Fig 1: Air Inflator Switch & Trim Bezel
    GM863926Courtesy of GENERAL MOTORS CORP.
  4. Remove the inflator retaining nut.
  5. Remove the air inflator switch from the trim bezel.
  6. Remove the rear quarter lower trim panel. Refer to Body Side Trim Panel Replacement - Right Side .
    7. Fig 2: Air Inflator Switch
    GM797660Courtesy of GENERAL MOTORS CORP.
  7. Remove the air inflator switch harness grommet from the body
  8. Remove the air inflator switch from the vehicle.
scientia non olet · About LEMON Manuals