LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Air Suspension) >> Repair Instructions >> Inflator Air Switch Replacement (SUV) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Air Inflator Switch
    GM797660Courtesy of GENERAL MOTORS CORP.
  1. Install the air inflator switch and harness assembly to the vehicle.
  2. Install the air inflator switch harness grommet to the body.
  3. Install in the rear quarter lower trim panel. Refer to Body Side Trim Panel Replacement - Right Side .
    4. Fig 2: Air Inflator Switch & Trim Bezel
    GM863926Courtesy of GENERAL MOTORS CORP.
  4. Install the air inflator switch to the trim bezel.
  5. Install the inflator retaining nut.
  6. Raise the vehicle.
  7. Connect the air inflator switch harness and the air line to the air compressor.
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals