Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Disengaging Bezel

Courtesy of GENERAL MOTORS CORP.

Open the rear liftgate.
Open the inflator switch door.
Using a flat-bladed tool, disengage the bezel from the rear trim panel.

Fig 2: Identifying Air Inflator Switch Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Disconnect the air inflator switch electrical connector (1).

Fig 3: Air Inflator Switch

Courtesy of GENERAL MOTORS CORP.

Remove the air inflator switch from the bezel.