LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Air Suspension) >> Repair Instructions >> Electronic Suspension Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the instrument panel trim plate bezel. Refer to Instrument Panel Center Trim Panel Replacement .
    2. Fig 1: Transfer Case Control Switch Module
    GM815899Courtesy of GENERAL MOTORS CORP.
  2. Remove the switch recepticle screws.
    3. Fig 2: Switch Receptacle & Instrument Panel
    GM815900Courtesy of GENERAL MOTORS CORP.
  3. Pull the switch recepticle from the instrument panel and disconnect the electrical connectors from the switch.
    4. Fig 3: Electronic Suspension Switch
    GM815943Courtesy of GENERAL MOTORS CORP.
  4. Remove the switch from the recepticle.
scientia non olet · About LEMON Manuals