LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Air Suspension) >> Repair Instructions >> Electronic Suspension Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Electronic Suspension Switch
    GM815943Courtesy of GENERAL MOTORS CORP.
  1. Install the switch to the recepticle.
    2. Fig 2: Switch Receptacle & Instrument Panel
    GM815900Courtesy of GENERAL MOTORS CORP.
  2. Connect the electrical connector to the switch. Install the switch recepticle to the instrument panel.
    3. Fig 3: Transfer Case Control Switch Module
    GM815899Courtesy of GENERAL MOTORS CORP.
    NOTE: Fastener Notice .
  3. Install the switch recepticle screws.

    Tighten:  Tighten the screws to 12 N.m (106 lb in).

  4. Install the instrument panel trim plate bezel. Refer to Instrument Panel Center Trim Panel Replacement .
scientia non olet · About LEMON Manuals