LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Air Suspension) >> Repair Instructions >> Dryer Automatic Level Control Replacement (Single Compressor) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Do NOT remove an air supply pipe in an attempt to depressurize the air suspension. Always follow the Air Suspension Depressurization Procedure in Air Suspension. Failure to follow this procedure may cause personal injury or damage to the vehicle.
  1. Remove the compressor assembly from the vehicle and place on a bench. Refer to Compressor Assembly Automatic Level Control Air Replacement (Dual Compressors)  or Compressor Assembly Automatic Level Control Air Replacement (Single Compressor) .
    2. IMPORTANT: Note the port location of the air lines for reassembly.
    Fig 1: Dryer Assembly
    GM1234308Courtesy of GENERAL MOTORS CORP.
  2. Remove the air lines. Refer to Air Suspension Air Line Replacement .
  3. Remove the mounting nuts (1).
  4. Remove the dryer assembly (2).
scientia non olet · About LEMON Manuals