Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Do NOT remove an air supply pipe in an attempt to depressurize the air suspension. Always follow the Air Suspension Depressurization Procedure in Air Suspension. Failure to follow this procedure may cause personal injury or damage to the vehicle.

Depressurize the air suspension system. Refer to Air Suspension Depressurization .
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .

Fig 1: Disconnecting Air Lines Procedure

Courtesy of GENERAL MOTORS CORP.

Disconnect all air lines using the following procedure. Air spring connection shown. All others are similar.
1. Push the air supply line into the air spring connection and hold in place.
2. Depress and hold the air supply line collet (2) down.
3. Remove the air supply line (1) from the air spring.
For air lines that are integral to a wiring harness. Trim off air line at the wiring harness with a sharp cutting tool. Leave the remaining air line in the wiring harness.