Installation Procedure
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- Install air line to the appropriate fitting until the line bottoms.
- Pressurize the air springs. Refer to Air Suspension Pressurization .
- Lower vehicle.
- Start the vehicle and run for approximately 2 minutes to verify that the air suspension system is functioning properly.
IMPORTANT:
Inspect the ends of all air supply pipes for deep scoring and sharp edges before reinstalling the pipe to the fitting. Replace any pipe that exhibits any of the above conditions.
IMPORTANT:
If the rear axle was allowed to hang unsupported, lower the vehicle far enough to allow the air spring to be manually engaged to the support on the axle tube with minimal distortion of the air spring bladder. Ensure that the air spring is fully engaged to the axle support.