LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Air Suspension) >> Repair Instructions >> Air Spring Leveling Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Air Spring Level Sensor
    GM793285Courtesy of GENERAL MOTORS CORP.
  1. Install the air spring level sensor to the frame.
    2. NOTE: Refer to Fastener Notice .
  2. Install the air spring level sensor to the frame mounting bolts.

    Tighten:  Tighten the air spring level sensor to the frame mounting bolts to 8.5 N.m (75 lb in).

  3. Connect the air spring level sensor electrical connector located on the frame.
    4. Fig 2: Air Spring Level Sensor Link
    GM793287Courtesy of GENERAL MOTORS CORP.
  4. Install the air spring level sensor link to the upper control arm.

    Tighten:  Tighten the bolt to 17 N.m (13 lb ft).

  5. Remove the rear axle support.
  6. Install the rear tire and wheels. Refer to Tire and Wheel Removal and Installation .
  7. Perform the suspension position calibration procedure. Refer to Suspension Position Calibration .
scientia non olet · About LEMON Manuals