LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Air Suspension) >> Diagnostic Information and Procedures >> Scan Tool Data List

Scan Tool Data List

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
Scan Tool Data List

Scan Tool Parameter Data List Units Displayed Typical Data Value
Operating Conditions: Vehicle in park with Ignition switch ON
ALC Exhaust Solenoid Data Display Active / Inactive Inactive
Battery Voltage Signal Data Display Volts 9 - 16
Compressor Relay Data Display ON / OFF OFF
Compressor Temperature Data Display OK / Hot OK
Door Switch Data Display Open / Closed Closed
Engine Running Data Display Yes / No No
ERH Lamp Command Data Display On / Off Off
ERH Switch Data Display Presse / Released Released
Height Sensor Current Data Display ma 19ma
Height Sensor Supply Status Data Display On / Off On
Ignition Data Display On / Off On
Ignition 3 Data Display Volts 12-14.7
Inflator Switch Data Display Pressed / Released Released
Inflator Switch Lamp Command Data Display ON / Off OFF
Left Height Sensor Data Display Volts 2.50-3.50
Left Isolation Valve Data Display Active / Inactive Inactive
Neutral Switch Data Display On / Off Off
Number of DTCs Data Display Number 0
Park Switch Data Display On / Off On
Ride Height Status Data Display Norma / Extended Normal
Right Height Sensor Data Display Volts 2.50-3.50
Right Isolation Valve Data Display Active / Inactive Inactive
Total Valve Current Data Display ma 0
Tow / Haul Mode Data Display Active / Inactive Inactive
Trim Height Learned Data Display Yes / No Yes
Vehicle Speed Data Display mph/km/h 0