Rear Brake Hose Replacement (Frame to Rear Axle JD9)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Frame To Rear Axle Brake Hose & Components

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
WARNING: Refer to Brake Fluid Warning . WARNING: Refer to Brake Fluid Irritant Warning . Preliminary Procedure Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
1	Brake Pipe Rear Fitting (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten 25 N.m (18 lb ft) Remove any dirt or debris from the brake pipe fitting. Use a backup wrench to hold the brake hose while removing or installing either the brake hose or brake pipe. Cap the brake pipe fitting to prevent brake fluid loss and contamination.
2	Brake Hose Bracket to Frame Rear Bolt Tighten 25 N.m (18 lb ft).
3	Brake Hose to Frame Rear Bracket
4	Brake Pipe Rear Fitting (Qty: 2) Remove any dirt or debris from the brake pipe fitting. Use a backup wrench to hold the brake hose while removing or installing either the brake hose or brake pipe. Cap the brake pipe fitting to prevent brake fluid loss and contamination. Tighten 25 N.m (18 lb ft)
5	Brake Hose Bracket to Axle Housing Rear Bolt Tighten 25 N.m (18 lb ft)
6	Frame to Axle Rear Brake Hose When installing the brake hose bracket to the axle housing, ensure the brake hose bracket is properly located and properly seated on the rear axle housing mounting bracket. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Pressure) , Hydraulic Brake System Bleeding (Two-mode Hybrid) , Hydraulic Brake System Bleeding (Manual) .
7	Brake Hose to Rear Axle Housing Bracket