Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install the vacuum brake booster check valve and hose assembly (1) and secure the clamp.
- Install the vacuum sensor with check valve and hose assembly (1) to the power vacuum brake booster.
- Connect the electrical connector to the vacuum sensor.
- Install the upper intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
NOTE:
A small amount of denatured alcohol may be used to ease assembly, if necessary.
NOTE:
A small amount of denatured alcohol may be used to ease assembly, if necessary.