LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 477 (Hydraulic Brake System) >> Repair Instructions >> Power Brake Booster Pump Fluid Accumulator Replacement (Two-Mode Hybrid) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: HPA O-ring Seal
    GM2037951Courtesy of GENERAL MOTORS COMPANY
  1. Lubricate a new O-ring seal (1) with Delco Supreme 11®, GM P/N 12377967 (Canadian P/N 992667), or equivalent DOT-3 brake fluid from a clean, sealed brake fluid container.
  2. Install the O-ring seal to the HPA. Ensure the seal is fully seated in the groove of the HPA and is not twisted.
    3. Fig 2: HPA
    GM2037950Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  3. Install the HPA (1) to the brake modulator assembly.

    Tighten 

    Tighten the HPA to 30 N.m (22 lb ft).

  4. Install the brake modulator assembly bracket and remove the support. Refer to Brake Pressure Modulator Valve Replacement .
    5. Fig 3: View Of Brake Modulator Manual Pressure Relief Valve
    GM2037952Courtesy of GENERAL MOTORS COMPANY
  5. Tighten the brake modulator manual pressure relief valve (1).

    Tighten 

    Tighten the valve to 40 N.m (30 lb ft).

  6. Perform the Antilock Brake System Automated Bleed . Follow the procedure completely to ensure the learn procedure for the pressure and travel sensors has occurred.
scientia non olet · About LEMON Manuals