Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install the 3 master cylinder reservoir seals (1).
Lubricate the master cylinder reservoir seals and the outer surface area of the reservoir-to-housing barrels with Delco Supreme 11®, GM P/N 12377967 (Canadian P/N 992667) or equivalent DOT-3 brake fluid from a clean, sealed brake fluid container.
- Install the master cylinder reservoir (1) to the master cylinder.
Ensure the master cylinder reservoir is seated fully into the master cylinder by pressing the reservoir straight down into the master cylinder.
- Install the brake master cylinder reservoir pins (1) and tighten to 8 N.m (71 lb in).
- Connect the brake master cylinder reservoir return hose quick connect (1).
- Connect the brake master cylinder reservoir supply hose quick connect (2).
- Connect the brake fluid level sensor electrical connector.
- Fill the brake master cylinder reservoir. Refer to Master Cylinder Reservoir Filling .
CAUTION:
Refer to Fastener Caution .
Fig 4: View Of Brake Master Cylinder Reservoir Return Hose Quick Connect & Supply Hose Quick Connect