Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install the supply and return hoses to the vehicle and the retainers.
- Connect the BPMV return hose quick connect (1).
Ensure the return hose quick connect is fully engaged by attempting to pull the return hose from the outlet fitting.
- Connect the BPMV supply hose quick connect (1).
Ensure the supply hose quick connect is fully engaged by attempting to pull the supply hose from the inlet fitting.
- Install the ABS module splash shield (1).
- Install the ABS module splash shield bolts (1) and tighten to 20 N.m (15 lb ft).
- Install the ABS module splash shield retainers (1).
- Lower the vehicle.
- Connect the brake master cylinder reservoir return hose quick connect (1).
- Connect the brake master cylinder reservoir supply hose quick connect (2).
- Fill the brake master cylinder reservoir. Refer to Master Cylinder Reservoir Filling .
CAUTION:
Refer to Fastener Caution .
Fig 6: View Of Brake Master Cylinder Reservoir Return Hose Quick Connect & Supply Hose Quick Connect