Brake Pedal Pushrod Inspection
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the brake pedal pushrod (1) from the brake pedal.
- Inspect the brake pedal pushrod eyelet bushing (2), if equipped, for cracks and/or excessive wear.
- Reposition the pedal pushrod boot (3) toward the front of the vehicle to expose as much of the pedal pushrod (1) as possible.
- Inspect the brake pedal pushrod (1) for straightness.
- If the brake pedal pushrod eyelet bushing (2) exhibited cracks and/or excessive wear, then the bushing requires replacement.
- If the brake pedal pushrod (1) is not straight, then the pushrod requires replacement.
- Return the pedal pushrod boot (3) to its original position on the pedal pushrod (1).
- Connect the brake pedal pushrod (1) to the brake pedal.