LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 476 (Antilock Brake System - Hybrid (Hp2)) >> Repair Instructions >> Rear Wheel Speed Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2012 GMC Yukon, 2012 Chevrolet Tahoe, and 2012 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Refer to Brake Dust Warning .

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: Identifying Rear Wheel Speed Sensor Electrical Connector & Harness Clips
    GM2178526Courtesy of GENERAL MOTORS COMPANY
  2. Disconnect the wheel speed sensor electrical connector (1).
  3. Release the wheel speed sensor electrical connector and sensor harness clips (2) from the inboard frame rail.
    4. Fig 2: Identifying Rear Wheel Speed Sensor Bolt
    GM2178527Courtesy of GENERAL MOTORS COMPANY
  4. Remove the wheel speed sensor bolt (1).
    5. Fig 3: Identifying Rear Wheel Speed Sensor
    GM2178528Courtesy of GENERAL MOTORS COMPANY
  5. Remove the wheel speed sensor (1) from the rear axle.
scientia non olet · About LEMON Manuals