Installation Procedure

WARNING: This page is about a different car, the 2012 GMC Yukon, 2012 Chevrolet Tahoe, and 2012 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of EBCM

Courtesy of GENERAL MOTORS COMPANY

Position the EBCM (1) to the BPMV.
Push the EBCM squarely onto the BPMV.

Fig 2: View Of EBCM Bolts

Courtesy of GENERAL MOTORS COMPANY

CAUTION:

Refer to Fastener Caution .

Install the EBCM bolts (1).
Tighten

Tighten the bolts in an X pattern to 3 N.m (27 lb in).
Connect the EBCM electrical connector.
If installing a new EBCM, the EBCM must be programmed and the sensor and boost valve calibration and EBCM learn processes must be performed. Refer to Control Module References .

Fig 3: ABS Module Splash Shield

Courtesy of GENERAL MOTORS COMPANY

Install the ABS module splash shield (1).

Fig 4: ABS Module Splash Shield Bolts

Courtesy of GENERAL MOTORS COMPANY

Install the ABS module splash shield bolts (1).
Tighten

Tighten the bolts to 20 N.m (15 lb ft).

Fig 5: ABS Module Splash Shield Retainers

Courtesy of GENERAL MOTORS COMPANY

Install the ABS module splash shield retainers (1).