LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 476 (Antilock Brake System - Hybrid (Hp2)) >> Diagnostic Information and Procedures >> StabiliTrak Indicator Malfunction >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2012 GMC Yukon, 2012 Chevrolet Tahoe, and 2012 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the traction control switch.
  2. Test for infinite resistance between the signal terminal 3 and the ground terminal 1 with the switch in the open position.
    • If not the specified value, replace the traction control switch.
  3. Test for less than 2 Ω between the signal terminal 3 and the ground terminal 1 with the switch in the closed position.
    • If greater than the specified range, replace the traction control switch.
scientia non olet · About LEMON Manuals