Circuit/System Testing

WARNING: This page is about a different car, the 2012 GMC Yukon, 2012 Chevrolet Tahoe, and 2012 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.

Verify DTC C0455 is not set.
- If DTC is set, refer to DTC C0455 .
Verify DTC C0277 is not set.
- If DTC is set, refer to DTC C0277, C120C, C129A, C129B, C129D, C129E, C12B1, or C12F8 .
Ignition OFF, disconnect the harness connector at the electronic brake control position sensor.
Ignition ON, test for 4.8-5.2 V between the 5 V reference circuit terminal 2 and ground.
- If less than the specified range, test the 5 V reference circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the EBCM.
- If greater than the specified range, test the 5 V reference circuit for a short to voltage. If the circuit tests normal, replace the EBCM.