Removal Procedure
WARNING: This page is about a different car, the 2012 GMC Yukon, 2012 Chevrolet Tahoe, and 2012 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Refer to Battery Disconnect Warning .
- Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
- Disconnect the engine wiring harness electrical connector (1) from the battery current sensor (2).
- Remove the negative battery cable clip (1) from the auxiliary bussed electrical center (BEC).
- Remove the negative battery cable ground terminal bolt (1) from the left side engine block boss.
- Remove the negative battery cable (3) and the engine wiring harness ground (2) leads from the engine block boss.
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the engine wiring harness ground lead bolt (1) from the frame.
- Remove the engine wiring harness ground lead (2) and the negative battery cable lead (3) from the frame.
- Lower the vehicle.
- Remove the negative battery cable assembly (1) from under the positive battery cable and from the vehicle.