LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 470 (Seat Heating System And Seat Cooling System) >> Diagnostic Information and Procedures >> DTC B2508 or B2509 (Rear Seat) >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the X1 harness connector at the RHSM.
  2. Test for infinite resistance between the control circuit terminal 3 and ground.
    • If not the specified value, test the control circuits listed below for a short to ground:
    • Left rear seat cushion terminal 3
    • Left rear seat cushion terminal 5
  3. Test for infinite resistance between the control circuit terminal 6 and ground.
    • If not the specified value, test the control circuits listed below for a short to ground:
    • Right rear seat cushion terminal 6
    • Right rear seat cushion terminal 2
  4. Ignition ON, verify that a test lamp does not illuminate between the control circuit terminal 3 and ground.
    • If the test lamp illuminates, test the control circuits listed below for a short to voltage:
    • Left rear seat cushion terminal 3
    • Left rear seat cushion terminal 5
  5. Verify that a test lamp does not illuminate between the control circuit terminal 6 and ground.
    • If the test lamp illuminates, test the control circuits listed below for a short to voltage:
    • Right rear seat cushion terminal 6
    • Right rear seat cushion terminal 2
  6. If all circuits test normal, replace the RHSM.
scientia non olet · About LEMON Manuals