LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 466 (Engine Controls/Fuel - 5.3L, 6.0L, 6.2L - Repair Instructions) >> Repair Instructions >> Heated Oxygen Sensor Replacement - Bank 2 Sensor 1 (1500 Series) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

Refer to Heated Oxygen and Oxygen Sensor Caution .

    Fig 1: View Of Engine Wiring Harness Electrical Connectors, (CPA) Retainers & Engine Harness Clips
    GM1704006Courtesy of GENERAL MOTORS COMPANY
  1. Remove the right wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Right Side .
  2. Remove the connector position assurance (CPA) retainer (2).
  3. Disconnect the HO2S electrical connector (7) from the engine wiring harness electrical connector (1).
  4. Remove the HO2S clip (8) from the engine wiring harness.
    5. Fig 2: View Of Catalytic Converter Assembly HO2S's
    GM1704008Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Excessive Force and Oxygen Sensor Caution .

  5. Remove the HO2S (3).
scientia non olet · About LEMON Manuals