LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 466 (Engine Controls/Fuel - 5.3L, 6.0L, 6.2L - Repair Instructions) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement (2500 Series) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:

Clean all fuel and evaporative emission (EVAP) line connections and surrounding areas prior to disconnecting the lines in order to avoid possible fuel and/or EVAP system contamination.

    Fig 1: View Of Fuel Tank Pressure Sensor (2500)
    GM1705812Courtesy of GENERAL MOTORS COMPANY
  1. Remove the intermediate fuel and evaporative emission (EVAP) lines. Refer to Fuel Hose/Pipe Assembly Replacement (1500 SWB - 98.4L (26 gal) Tank + E85) , Fuel Hose/Pipe Assembly Replacement (1500 LWB - 117.3L (31 gal) Tank) , Fuel Hose/Pipe Assembly Replacement (1500 LWB - 117.3L (31 gal) Tank + E85) , Fuel Hose/Pipe Assembly Replacement (1500 SWB - 98.4L (26 gal) Tank) .
  2. Gently pry straight up, in order to remove the fuel pressure sensor.
scientia non olet · About LEMON Manuals