Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Refer to Gasoline/Gasoline Vapors Warning .
WARNING:
Remove the fuel tank cap and relieve the fuel system pressure before servicing the fuel system in order to reduce the risk of personal injury. After you relieve the fuel system pressure, a small amount of fuel may be released when servicing the fuel lines, the fuel injection pump, or the connections. In order to reduce the risk of personal injury, cover the fuel system components with a shop towel before disconnection. This will catch any fuel that may leak out. Place the towel in an approved container when the disconnection is complete.
- Relieve the fuel system pressure. Refer to Fuel Pressure Relief (Without CH-48027) , Fuel Pressure Relief (CH-48027) .
- Connect the CH-48027-1 (1) to the CH-48027-2 (2).
- Remove the shop towel from around the fuel rail service port, and place in an approved gasoline container.
- Perform any tests and/or diagnostics as needed. For the proper usage of the CH-48027 digital pressure gauge, refer to the manufacture's directions.