LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 466 (Engine Controls/Fuel - 5.3L, 6.0L, 6.2L - Repair Instructions) >> Repair Instructions >> Fuel Hose/Pipe Assembly Replacement (1500 LWB - 117.3L (31 gal) Tank) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:

Clean the fuel feed line connection and surrounding area prior to disconnecting the fitting in order to avoid possible fuel system contamination.

    Fig 1: View Of Fuel Feed Line Retainer & EVAP Line Clip
    GM1704744Courtesy of GENERAL MOTORS COMPANY
  1. Remove the fuel tank. Refer to Fuel Tank Replacement (1500 LWB - 117.3L (31 gal) Tank + E85) , Fuel Tank Replacement (1500 SWB - 98.4L (26 gal) Tank) , Fuel Tank Replacement (1500 SWB - 98.4L (26 gal) Tank + E85) , Fuel Tank Replacement (2500 LWB - 4.35L (11.5 gal) Tank Rear) , Fuel Tank Replacement (1500 LWB - 117.3L (31 gal) Tank) , Fuel Tank Replacement (2500 LWB - 98.4L (26 gal) Tank Front) .
  2. Remove the fuel feed line from the retaining feature (2) in the fuel tank.
  3. Open the fuel/EVAP line clip (1) and remove the fuel feed line from the clip.
  4. Disconnect the fuel feed line quick connect fitting at the fuel tank module. Refer to Plastic Collar Quick Connect Fitting Service .
    5. Fig 2: View Of Fuel Feed Line
    GM1704745Courtesy of GENERAL MOTORS COMPANY
  5. Remove the fuel feed line from the fuel tank.
  6. Cap the fuel feed port on the fuel tank module in order to prevent possible fuel system contamination.
scientia non olet · About LEMON Manuals