LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 466 (Engine Controls/Fuel - 5.3L, 6.0L, 6.2L - Repair Instructions) >> Repair Instructions >> Evaporative Emission System Hose/Pipe Replacement (2500 LWB - 98.4L (26 gal) Tank-Front) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Tank EVAP Lines
    GM1705659Courtesy of GENERAL MOTORS COMPANY
  1. Install the fuel/EVAP lines to the fuel tank.
    2. Fig 2: View Of Fuel Tank Clips
    GM1705656Courtesy of GENERAL MOTORS COMPANY
  2. Connect the fuel/EVAP line quick connect fittings at the fuel tank module. Refer to Plastic Collar Quick Connect Fitting Service .
  3. Install the fuel/EVAP lines to the fuel tank clips (2-7) and close the clips.
  4. Install the fuel/EVAP line to the fuel tank clip (1).
    5. Fig 3: View Of Fuel Tank Shield & Retainers
    GM1705654Courtesy of GENERAL MOTORS COMPANY
  5. Install the fuel tank shield (2) and retainers (1).
  6. Install the fuel tank. Refer to Fuel Tank Replacement (1500 LWB - 117.3L (31 gal) Tank + E85) , Fuel Tank Replacement (1500 SWB - 98.4L (26 gal) Tank) , Fuel Tank Replacement (1500 SWB - 98.4L (26 gal) Tank + E85) , Fuel Tank Replacement (2500 LWB - 4.35L (11.5 gal) Tank Rear) , Fuel Tank Replacement (1500 LWB - 117.3L (31 gal) Tank) , Fuel Tank Replacement (2500 LWB - 98.4L (26 gal) Tank Front) .
scientia non olet · About LEMON Manuals