LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 466 (Engine Controls/Fuel - 5.3L, 6.0L, 6.2L - Repair Instructions) >> Repair Instructions >> Evaporative Emission Line Replacement - Canister to Tank (2500 LWB - 43.5L (11.5 gal) Tank-Rear) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:

Clean the evaporative emission (EVAP) line connections and surrounding areas prior to disconnecting the fittings in order to avoid possible EVAP system contamination.

    Fig 1: View Of EVAP Line Clips
    GM1705753Courtesy of GENERAL MOTORS COMPANY
  1. Remove the rear fuel tank. Refer to Fuel Tank Replacement (1500 LWB - 117.3L (31 gal) Tank + E85) , Fuel Tank Replacement (1500 SWB - 98.4L (26 gal) Tank) , Fuel Tank Replacement (1500 SWB - 98.4L (26 gal) Tank + E85) , Fuel Tank Replacement (2500 LWB - 4.35L (11.5 gal) Tank Rear) , Fuel Tank Replacement (1500 LWB - 117.3L (31 gal) Tank) , Fuel Tank Replacement (2500 LWB - 98.4L (26 gal) Tank Front) .
  2. Remove the EVAP line from the clip (1) on the fuel tank.
  3. Open the EVAP line clip (2) and remove the EVAP line from the clip.
  4. Remove the EVAP lines from the clip (3).
  5. Disconnect the EVAP line quick connect fittings from the fuel tank module. Refer to Plastic Collar Quick Connect Fitting Service .
    6. Fig 2: View Of Fuel Tank EVAP Lines
    GM1705754Courtesy of GENERAL MOTORS COMPANY
  6. Remove the EVAP lines from the fuel tank.
scientia non olet · About LEMON Manuals