LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 466 (Engine Controls/Fuel - 5.3L, 6.0L, 6.2L - Repair Instructions) >> Repair Instructions >> Accelerator Pedal Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

Handle the electronic throttle control components carefully. Use cleanliness in order to prevent damage. Do not drop the electronic throttle control components. Do not roughly handle the electronic throttle control components. Do not immerse the electronic throttle control components in cleaning solvents of any type.

    Fig 1: View Of APP Sensor Electrical Connector
    GM1704152Courtesy of GENERAL MOTORS COMPANY
  1. Push down the small tab and disconnect the accelerator pedal position (APP) sensor electrical connector (1).
    2. Fig 2: View Of Accelerator Pedal Position Sensor Assembly
    GM1704147Courtesy of GENERAL MOTORS COMPANY
  2. Remove the accelerator pedal bolts.
  3. Remove the accelerator pedal.
scientia non olet · About LEMON Manuals