LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 464 (Wiring Systems And Power Management - Repair Instructions) >> Repair Instructions >> Ignition Lock Cylinder Case Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING:

    Refer to SIR Warning .

  1. Remove the inflatable restraint steering wheel module coil. Refer to Steering Wheel Airbag Coil Replacement .
  2. Remove the ignition/start switch. Refer to Ignition and Start Switch Replacement .
  3. Disconnect the park lock cable from the ignition lock cylinder case.
  4. Disconnect the passlock and key buzzer from the ignition lock cylinder case.
    5. Fig 1: View Of Ignition Lock Cylinder & Screws
    GM1700676Courtesy of GENERAL MOTORS COMPANY
  5. Remove the 3 ignition lock cylinder case screws (2).
  6. Remove the ignition lock cylinder case (1) from the vehicle.
scientia non olet · About LEMON Manuals