LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 464 (Wiring Systems And Power Management - Repair Instructions) >> Repair Instructions >> Ignition Lock Cylinder Case Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Ignition Lock Cylinder & Screws
    GM1700676Courtesy of GENERAL MOTORS COMPANY
  1. Install the ignition lock cylinder case (1) to the vehicle.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the 3 ignition lock cylinder case screws (2).

    Tighten 

    Tighten the screws to 7 N.m (62 lb in).

  3. Install the park lock cable into the lock cylinder housing.
  4. Connect the passlock and key buzzer to the ignition lock cylinder case.
  5. Install the ignition/start switch. Refer to Ignition and Start Switch Replacement .
  6. Install the inflatable restraint steering wheel module coil. Refer to Steering Wheel Airbag Coil Replacement .
scientia non olet · About LEMON Manuals