Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install the surge tank outlet hose.
- Install the surge tank outlet hose to the water pump.
- Position the surge tank outlet hose clamp to the water pump.
- Install the surge tank outlet hose (2) to the surge tank.
- Position the surge tank outlet hose clamp to the surge tank.
- If equipped with RPO C36 auxiliary heater, connect the surge tank outlet hose to the heater and blower module.
- If equipped without RPO C36 auxiliary heater, connect the surge tank outlet hose to the heater and blower module.
Firmly push the hose onto the heater and blower module pipe until an audible click is heard.
- If equipped with RPO C36 auxiliary heater, install the surge tank/heater outlet hose (1) to the mounting clip.
- If equipped without RPO C36 auxiliary heater, install the surge tank/heater outlet hose (1) to the mounting clip.
- Install the air cleaner outlet duct.
- Align the arrow at the throttle body end of the duct with the throttle body attaching stud.
- Tighten the air cleaner outlet duct clamps at the following locations:
- Throttle body
- MAF/IAT sensor
Tighten
Tighten the clamps to 7 (62 lb in).
- Fill the cooling system. Refer to Cooling System Draining and Filling (Static Fill) .
Fig 8: View Of Throttle Body End Arrow & Throttle Body Attaching Stud (4.8L, 5.3L, and 6.0L Engines)
CAUTION:
Refer to Fastener Caution .