LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 463 (Engine Cooling System) >> Repair Instructions >> Engine Oil Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Generator Cooling Inlet Pipe & Generator Cooling Inlet Pipe Fitting
    GM1195424Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Discard the EOC retaining clip and install a new retaining clip.

  1. Install the EOC pipe into the EOC pipe fitting.

    A distinct snap should be heard or felt when assembling the EOC pipe to the fitting.

  2. To ensure the cooler line is properly installed, give the cooler pipe a gentle pull.
scientia non olet · About LEMON Manuals