Draining Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
To avoid being burned, do not remove the radiator cap or surge tank cap while the engine is hot. The cooling system will release scalding fluid and steam under pressure if radiator cap or surge tank cap is removed while the engine and radiator are still hot.
- Follow the steps below in order to remove the surge tank fill cap:
- Slowly rotate the cap counterclockwise.
- Stop rotating and allow the hissing to stop.
- After all the hissing stops, continue turning counterclockwise in order to remove the cap.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Place a drain pan under the lower radiator hose and/or drain cock.
- Using the J 38185 hose clamp pliers, reposition the lower radiator hose clamp.
- Reposition the lower radiator hose and/or drain cock from the radiator.
- Drain the cooling system.
- If a complete engine block drain is required, remove the left and right engine block coolant drain plugs.
- Remove the engine block coolant heater, if equipped. Refer to Coolant Heater Replacement (With LY2, LMG, LY5, LY6 or LFA) , Coolant Heater Replacement (With LC9, L76, or L92) .
- Inspect the coolant.
- Follow the appropriate procedure based on the condition of the coolant:
- Normal in appearance-Follow the filling procedure.
- Discolored-Follow the flush procedure. Refer to Flushing .