LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 463 (Engine Cooling System) >> Repair Instructions >> Cooling Fan and Shroud Replacement (Non-HP2) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the cooling system. Refer to Cooling System Draining and Filling (Static Fill) 
  2. Remove air inlet duct.
  3. Disconnect upper radiator hose from radiator.
    4. Fig 1: Radiator, Inlet & Outlet Hose & Clamps
    GM1486075Courtesy of GENERAL MOTORS COMPANY
  4. Disengage the radiator inlet hose clip (2) at the fan shroud.
    5. Fig 2: View Of Surge Tank Inlet Hose & Clamps
    GM1698684Courtesy of GENERAL MOTORS COMPANY
  5. If necessary, reposition the surge tank inlet hose clamp at the radiator.
  6. If necessary, remove the surge tank inlet hose from the radiator.
    7. Fig 3: Cooling Fan Electrical Connectors
    GM1480471Courtesy of GENERAL MOTORS COMPANY
  7. Disconnect the electrical connectors from the cooling fans.
  8. Remove the clip attaching the wiring harness to the shroud.
  9. Remove transmission cooler lines bolts from fan shroud.
    10. Fig 4: Engine Oil Cooler Quick Connect Fittings
    GM1486208Courtesy of GENERAL MOTORS COMPANY
  10. If necessary, open the engine oil cooler line clip and remove the cooler lines from the clip.
    11. Fig 5: Cooling Fan Shroud & Bolts
    GM1485882Courtesy of GENERAL MOTORS COMPANY
  11. Remove the cooling fan shroud bolts.
  12. Remove the cooling fan and shroud.
scientia non olet · About LEMON Manuals