Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install the cooling fan and shroud.
- Install the cooling fan shroud bolts.
Tighten
Tighten the bolts to 9 N.m (80 lb in).
- If equipped, install the cooler lines to the clip and close the clip.
- Connect the electrical connectors to the cooling fans.
- Install the clip attaching the wiring harness to the shroud.
- Install the transmission cooling line bolts to fan shroud.
Tighten
Tighten the bolts to 4 N.m (35 lb in).
- If necessary, install the surge tank inlet hose to the radiator.
- If necessary, reposition the surge tank inlet hose clamp at the radiator.
- Engage the radiator inlet hose clip (2) at the fan shroud.
- Connect upper radiator hose from radiator.
- Install air inlet duct.
- Fill the cooling system. Refer to Cooling System Draining and Filling (Static Fill)
NOTE:
Insert the 3 lower tabs into the radiator support flange. Keeping the shroud parallel to the radiator will ensure the correct installation of the lower tabs.
CAUTION:
Refer to Fastener Caution .