LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 463 (Engine Cooling System) >> Repair Instructions >> Coolant Heater Cord Replacement (With LY2, LY5 or LMG) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Pan Skid Plate & Bolts
    GM1698082Courtesy of GENERAL MOTORS COMPANY
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the oil pan skid plate bolts and plate, if equipped.
    3. Fig 2: View Of Coolant Heater Cord
    GM1699548Courtesy of GENERAL MOTORS COMPANY
  3. Disconnect the coolant heater cord electrical connector.
    4. Fig 3: View Of Coolant Heater Cord & Components
    GM1702203Courtesy of GENERAL MOTORS COMPANY
  4. Remove the coolant heater cord retainer (5) from the frame.
  5. Remove the coolant heater cord clip (6) from the front brake front pipe.
  6. Lower the vehicle.
  7. Remove the coolant heater cord bolt (4) from the frame.
  8. Remove the coolant heater cord clip (2) from the chassis harness.
  9. Remove the coolant heater cord clip (1) from the front spring stud.
  10. Remove the coolant heater cord from the vehicle.
scientia non olet · About LEMON Manuals