LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 461 (Wiring Systems And Power Management - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Repairing Connector Terminals (Terminal Repair) >> Unsealed Terminals

Unsealed Terminals

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Cut off the terminal between the core and the insulation crimp to minimize any wire loss.
  2. To minimize wire loss, remove only the insulation required.
  3. Position the stripped wire in the terminal.
  4. Hand Crimp the core wings first.
  5. Hand Crimp the insulation wings around the cable.
  6. Solder all of the hand crimp terminals except the Micro-Pack 100 and 0.64 sizes.
scientia non olet · About LEMON Manuals