LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 461 (Wiring Systems And Power Management - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> FCI Connectors (SIR) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

The orange connector position assurance (CPA) must be released first to disconnect or to connect the connector.

    Fig 1: View Of Lifting Orange CPA
    GM2374625Courtesy of GENERAL MOTORS COMPANY
  1. Lift the orange CPA vertically (avoid lifting on an angle to the connector) approximately 4 mm to release the connector. Use a small flat-bladed tool to help release the orange CPA. The orange CPA can also be released manually without any tools.
    2. Fig 2: Orange CPA
    GM2374627Courtesy of GENERAL MOTORS COMPANY
  2. Grab the connector on both sides and lift the connector vertically to disconnect the connector.
scientia non olet · About LEMON Manuals