LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 461 (Wiring Systems And Power Management - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Delphi Connectors (Pull To Seat) >> Terminal Insertion Procedure

Terminal Insertion Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the terminal and pull the wire from the back of the connector in order to seat the terminal.
  2. If the connector is outside of the passenger compartment, apply dielectric grease to the connector.
  3. Install the TPA, CPA, and/or the secondary locks.
scientia non olet · About LEMON Manuals