LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Power Steering) >> Repair Instructions >> Steering Gear Pitman Shaft and Housing Cover Replacement - Off Vehicle >> Assembly Procedure

Assembly Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Pitman Shaft Assembly (700 Gear)
    GM322009Courtesy of GENERAL MOTORS CORP.
  1. Screw the pitman shaft (4) to the side cover (8) until it fully seats to the side cover (8).
  2. Install the adjuster lock nut (1). Do not tighten the adjuster lock nut (1) until the pitman shaft adjustment is completed.
  3. Install the pitman shaft assembly (4) and the side cover (8) to the steering gear housing (7).
    4. NOTE: Refer to Fastener Notice .
  4. Install the bolts (2).

    Tighten:  Tighten the bolts (2) to 60 N.m (45 lb ft).

    5. Fig 2: Pitman Shaft, Nut And Lock Washer (700 Gear)
    GM322090Courtesy of GENERAL MOTORS CORP.
  5. Install the lock washer (2).
  6. Install the nut (3).
  7. If necessary, adjust the pitman shaft. Refer to Pitman Shaft Over-Center Preload Adjustment - Off Vehicle  to adjust the pitman shaft.
scientia non olet · About LEMON Manuals